Tap and learn: the airport
Tap a numbered marker, or pick it from the list. Each one says what it is and what to do.
Tap a marker
Wind sock, segmented circle, runway markings, hold short lines, signs, beacon and PAPI lights are all on this airport.
- The large end of the wind sock points into the wind. It shows wind direction near the runway in use.
- At airports without an operating control tower, the segmented circle is a visual system that gives traffic pattern information. It sits where pilots can see it from the air and the ground.
- The small end of the tetrahedron points in the direction of landing. Use it only as a landing direction indicator, never to judge wind. Tower instructions always come first.
- Placed in pairs with the landing strip indicators. They show which way to turn when the pattern is not the normal left pattern. With no indicator, all turns are to the left.
- A white and green flashing beacon marks a lighted land airport. Green alone also marks a lighted land airport. White and yellow marks a lighted water airport.
- The number is one-tenth of the runway's magnetic heading, rounded to the nearest whole number, read from the approach direction. The two ends of one runway differ by 18. Letters L, C and R separate parallel runways.
- A line of evenly spaced stripes and gaps down the middle of the runway. It gives alignment guidance for takeoff and landing.
- Eight stripes along the runway centerline, or fewer on narrower runways. They mark the beginning of the runway that is available for landing.
- A threshold that is not at the start of the pavement. A ten-foot-wide white bar crosses the runway there, with white arrows on the centerline before it. The pavement behind it is available for takeoffs either way and for landings from the opposite direction, but not for landing toward it.
- Two broad white stripes, one on each side of the centerline, about 1,000 feet from the landing threshold. They give you a visual aiming point for landing.
- Pairs of bars in groups of one, two and three, coded in 500-foot steps along the runway. They are part of the markings on precision instrument runways.
- Continuous white stripes along both edges of the runway. They separate the pavement from the ground beside it. Precision instrument runways have them.
- Four yellow lines, two solid and two dashed, across the taxiway. The solid lines are on the side where you must hold. Stop so no part of the airplane crosses the line, unless cleared onto the runway.
- A single continuous yellow line. Keep the airplane centered over it while taxiing. Being centered does not guarantee wingtip clearance.
- Black background, yellow letters and a yellow border. It tells you which taxiway you are on.
- A single row of two or four light units, normally on the left side of the runway. They give you a visual glide path. They can be seen about 5 miles by day and up to 20 miles at night. Do not start down until you are lined up with the runway.
Sources: FAA Aeronautical Information Manual: 2-1-2 Visual Glideslope Indicators, 2-1-9 Beacons, 2-3-3 Runway Markings, 2-3-4 Taxiway Markings, 2-3-5 Holding Position Markings, 2-3-9 Location Signs, 4-3-4 Visual Indicators at Airports Without an Operating Control Tower (2026 edition with changes 1 to 3).
One made-up airport, simplified and not to scale. Real airports differ; read the airport diagram and Chart Supplement for the one you fly to. Runway 9 numbers on this airport are drawn as 09 on the pavement.